 |
|
|
Autonomous
operation
Simultaneous
9-chain (40 station) monitoring
Quantitative
signal parameters
Complete
PC interface/control
12
automatic interference cancellers
Software
selectable clock and monitoring outputs
Accepts
1, 5, or 10 MHz Cesium clock input
46
cm (18”) antenna
High-performance
OCXO
|
| |
Locus’ LRS IIID is the most sophisticated Loran monitoring
receiver in the world, and was specially designed to meet USCG specifications.
It can track over 40 stations simultaneously, and replaces as many
as five other monitoring receivers. The U.S. and Canadian Coast
Guards use LRS IIID to monitor and control and North American Loran
transmissions. LRS IIIDs have also been recently installed by the
Japanese Coast Guard.
The LRS IIID is a computerized automatic receiver incorporating
digital signal processing (DSP) technology. This greatly enhances
its monitoring performance, including local phase code interval
(LPCI) resolution. The LRS IIID receives and processes Loran-C data
into both Time of Arrival and Time Differences. The LRS IIID has
complete PC interface and control to support remote data acquisition,
operation and diagnostics. Manual controls are eliminated, increasing
reliability.
|
|
|
|
Antenna
The low profile (~18”) of Locus’ patented LRS IIID active
antenna and preamp with integral band-pass filter does not limit
its sensitivity or performance. In fact, its RF immunity is 500%
better than that of non-tuned preamps. The LRS IIID antenna includes
an automatic 36dB attenuation that allows it to operate in close
proximity to Loran-C transmitters.
|
| |
Modern Receiver Technology
LAD receiver technology offers a 3 dB S/N advantage over hard limited
receivers. Extensive quantitative signal parameters are available
to the user. The patented ensemble-averaging architecture provides
rapid cycle detection and is virtually immune to cycle slip. Acquisition
time is 10 times faster than conventional receivers.
The LRS IIID offers true multichain acquisition and tracking (9
chains/40 stations), and crossrate lockout with ensemble averaging
improves signal-to-noise 15 dB. ECD and position stability are also
significantly improved versus legacy receivers.
Locus' proprietary notch filter technology eliminates notch filter
effects on ECD, SNR and sky waves. They are full band automatic
notch filters with software override. |
| |
Inputs and Outputs
The LRS IIID includes a high-performance OCXO and accepts external
clock inputs. It provides analog outputs of the Loran-C signal before
(Raw RF) and after (Scope) notch filters and gain, as well as oscilloscope
trigger and tracking outputs.
|
| |
The LRS IIID System
The LRS IIID system includes the LRS IIID receiver, the LRS IIID
antenna, one end-user software license, external lightning protection,
antenna cable and user documentation. |
| |
Applications
· Loran-C monitoring and control systems
· Precise time and frequency reference (Cs synchronized)
· Aviation, marine and terrestrial navigation
|
| |
| |
Technical Specifications Table |
Receiver |
Signal Level |
20-156 dBuV/m |
| Notch Filter |
12 automatic, processor controlled, full band |
Stations |
Tracks up to 9 chains simultaneouslyTracks up to 40 stations
simultaneously(Dual rated station = 2 stations) |
|
Inputs/Outputs |
Scope Outputs |
1 receiver conditioned Loran analog signalScope
Trigger, Raw RFScope Track Point and RF Gate |
Communications |
(2) RS-232 ports, 1200 bps to 115 KbpsSoftware selectable
to PC compatible values |
Special Inputs |
1,5 or 10 MHz clock inputLocal PCI resolved to within 6
ns |
Time/Frequency Outputs |
0.2 Hz to 10 MHz TTL level square wave1 PPS, TTL level
into 50 ohms |
|
Input Power |
AC Voltage |
100-260 VAC @ 47 to 63 Hz |
AC Current |
0.3A maximum @ 100 VAC input |
DC Voltage |
18-30 VDC |
DC Current |
1.5A @ 18 VDC maximum |
|
Environmental |
Operating Temperature |
0°C to +55°C |
Storage Temperature |
-40°C to +85°C |
Humidity |
5% to 95%, non-condensing |
|
Physical |
Dimensions |
490 x 140 x 330 mm (19.3” W x 5.5”
H x 13” D) |
Weight |
8 kg (18lb.) |
|
Antenna |
E-Field
|
46 cm (18”) heightExternal amplifier
powered through cableBuilt-in attenuation for monitoring applications-40°C
to +70°C operating temperature |
|
|
LAD Loran
LRS IIID Documentation |
| |